Printronix L5020 - Manual (Page 59)

Paper Control Menu
59
A form length setting of five inches results in a paper length
setting of 10 inches, as five is below the valid range.
• Inch Select/Length in Inches. This allows you to set the paper
length in inches. The range is 7.0 to 20.0 inches, in one-half
inch increments. The default is 11.0 inches.
• 6 LPI Select/Length at 6LPI. This menu selection allows you to
set the paper length in lines. The range is from 42 to 120 lines,
in 1 line increments. The default is 66 lines.
Fanfold Output
The Fanfold Output option specifies the paper path through the
stacker. You can select either into the stacker (default) or to bypass
the stacker.
Horizontal Image Shift
Horizontal Image Shift specifies the amount to shift an image to the
right for precise positioning on the page. The actual width of the
image is not affected. The allowable range is -1.0 to 1.0 inches, in
1/100 inch increments. The default is 0.0 inches.
Vertical Image Shift
Vertical Image Shift specifies the amount to shift an image down for
precise positioning on the page. The actual height of the image is
not affected. The allowable range is -1.0 to 1.0 inches, in 1/100 inch
increments. The default is 0.0 inches.
Toner
The Toner option sets the frequency interval for dispensing toner.
The higher the number selected, the less frequently toner is
dispensed. The allowable range is from 1 to 254. The default is 3.
Reprint On Fault
Reprint on Fault enables (default) or disables automatic reprinting
after a fault condition occurs. If Confirm is selected, the printer
displays a message asking if you want to reprint.