Pitney Bowes DM1000 - Manual (Page 125)

9-4 SV60951 Rev. A
9 Maintaining and Updating
Cleaning the
Moistener Brush
1. Move the tape lever to the up
position.
2. Move the brush lever to the right to
pull the brush mechanism forward.
3. Remove the brush.
4. Rinse the brush under cold water,
separating the bristles to remove
excess glue and deposits.
5. Lift the brush out by pulling up on
the bristles.
6. Place the brush in the case, two or
three teeth away from the bottom.
The shorter bristles should be
against the solid side of the holder.
7. Return the case to the brush
mechanism using the lever.
8. Return lever to original position.
9. Return tape lever to the required
position.
• Wet Tape– Lever up
• Dry Tape– Lever down
Changing the
Moistener Brush Follow steps 1 through 8 of How to Clean the Moistener Brush, but DO
NOT do step 4.
How To Clean the Moistener Brush
Need pictures
2-3 Teeth away From Bottom
Short Bristles
tape
lever
>
>