Pitney Bowes DM1000 - Manual (Page 126)

9
SV60951 Rev. A
9-5
DM1000 Operating Guide
Your mailing machine accepts gummed or adhesive tape. Tapes require
minimal threading, feeding, or adjusting. Each one has a colored stripe
approximately 36 in. from the end to indicate a low tape condition. You
should replace the tape when the stripe appears. Installing a
Roll Tape
1. Open the main cover.
2. Remove the old tape core.
3. Push the feed lever to the left and remove any tape scraps from the
feeding area. Release the lever.
4. Tear off the end of the new roll tape to leave a straight edge.
5. Drop the new roll tape into the well with gummed or adhesive
surface facing down.
Make sure the leading tape edge comes up from under the roll and
to the right as shown in the picture below.
How To Replace the Tape
6. Push the feed lever to the left and hold while inserting the leading
edge of the tape into the gap between the roller and the track.
7. Release the feed lever.
8. Close the cover. The tape advances to the proper position.
feed lever
gap between
roller and track
>
>