NetComm NP2724M - Manual (Page 34)

This command configure the number of hops in a region.
Format spanning-tree max-hops <1-40>
Mode Global Config
6) spanning-tree port
6.1) spanning-tree port all
This command specifies RSTP capability for all ports.
Format spanning-tree port all {enable |disable}
Mode Global Config
6.2) spanning-tree port cost
This command configures RSTP port path cost.
Format spanning-tree port cost <0-200000000>
Mode Global Config
6.3) spanning-tree port priority
This command configures RSTP port priority.
Format spanning-tree port priority <0-24>
Mode Global Config
6.4) spanning-tree port edge
This command configures STP edge .
Format spanning-tree port edge {enable|disable}
Mode Global Config
6.5) spanning-tree port force-p2plink
This command configures force point to point link mode on ports.
Format spanning-tree port force-p2plink {auto|enable|disable}
Mode Global Config
6.6) spanning-tree port migration-check
This command Re-checks the appropriate BPDU format to send on
ports.
Format spanning-tree port migration-check {enable|disable}
Mode Global Config
7) spanning-tree priority
This command configures RSTP bridge priority value.
Format spanning-tree priority <0-61440>
Mode Global Config
8) spanning-tree mst
Configure a multiple spanning tree instance.
8.1) spanning-tree mst instance
This command creates or removes a MST instance
8.1.1) spanning-tree mst instance add
This command creates a MST instance.
Format
spanning-tree mst instance add vlan <vlan list> mstpid <MST
ID>
Mode Global Config
e.g. Switch(Config)# Spanning-Tree mst instance add vlan 2-5 mstpid 2
Switch(Config)# Spanning-Tree mst instance add vlan 6 mstpid 3
8.1.2) spanning-tree mst instance delete
This command removes the last MST instance.
Format spanning-tree mst instance delete
Mode Global Config
8.2) spanning-tree mst vlan
This command adds or deletes vlan frome a MSTP instance.
8.2.1) spanning-tree mst vlan <MST ID> <vlan list> add
NP2724M User Manual 33