NetComm NP2724M - Manual (Page 37)

This command clears a source mac address.
Format Access-list name <WORD> clear mac SA
Mode Global Config
3.6) access-list name <WORD> clear MAC DA
This command clears a destination mac address.
Format Access-list name <WORD> clear mac DA.
Mode Global Config
3.7) access-list name <WORD> clear VID
This command clears the 802.1Q VLAN tag of packet.
Format Access-list name <WORD> clear VID
Mode Global Config
3.8) access-list name <WORD> clear ether-type
This command clears ether type filter.
Format access-list name <WORD> clear ether-type
Mode Global Config
4) access-list name <WORD> deletes.
This command removes the ACL entry.
Format access-list name <WORD> deletes
Mode Global Config
5) access-list name <WORD> {enable|disable}
This command enables/disables the ACL entry.
Format access-list name <WORD> {enable|disable}
Mode Global Config
6) access-list name <WORD> set
6.1) access-list name <WORD> set priority
This command specifies ACL entry priority.
Format access-list name <WORD> set priority <0-65535>
Mode Global Config
6.2) access-list name <WORD> set IP-mode
6.2.1) access-list name <WORD> set IP-mode SRC IP.
This command specifies a source IP address.
Format access-list name <WORD> set IP-mode SRC IP <IP-
addr> <mask-addr>
Mode Global Config
6.2.2) access-list name <WORD> set IP-mode DST IP
This command specifies a destination IP address.
Format access-list name <WORD> set IP-mode DSP IP <IP-
addr> <mask-addr>
Mode Global Config
6.3) access-list name <WORD> set L4port
This command specifies the TCP/UDP port range.
6.3.1) access-list name <WORD> set l4port SRC-port
This command specifies the source TCP/UDP port range.
Format Access-list name <WORD> set L4 port SRE-port from <1-
65535> to <1-65535>
Mode Global Config
6.3.2) access-list name <WORD> set l4port DST-port
This command specifies the destination TCP/UDP port range.
Format access-list name <WORD> set l4port DST-port from <1-
65535> to <1-65535>
Mode Global Config
NP2724M User Manual 36