NetComm NP2724M - Manual (Page 43)

Format vlan participation exclude < vlan id>
Mode Interface Config
1.2) vlan participation
This command join a vlan with untagged/tagged mode.
Format vlan participation {untagged |tagged}< vlan id>
Mode Interface Config
2) vlan protected
This command configures port protected property.
Format vlan protected {enable|disable}
Mode Interface Config
3) vlan dropnq
This command configure port drop none 802.1Q frame .
Format vlan dropnq {enable|disable}
Mode Interface Config
4) vlan pvid
This command configure port PVID.
Format vlan pvid <pvid>
Mode Interface Config
e.g. Switch(Interface 1)# vlan pvid 1
Interface commands
This command change another interface
Format Interface <port number>
Mode Interface Config
e.g. Switch(Interface 1)# interface g1
poe
1) func
This command configure poe function on a port
Format poe func {enable | disable}
Mode Interface Config
2) power-pri
This command configures the power priority on switch ports to decide which
ports have priority to supply power which power devices are connected.
Legal value are low, normal, middle or high priority. If the same power
priority on the ports, the lower port index the higher power priority.
Low Set to low priority
Normal Set to normal priority
Middle Set to middle priority
High Set to high priority
Format poe power-pri level {low | normal | middle | high}
Mode Interface Config
3)detection
This command configures detection type on a port. set to 0,1,2,3,4 or 5
0 No Detection
1 Legacy Capacitive Detection only
2 IEEE 802.3af 4-Point Detection only (Default)
3 IEEE 802.3af 4-Point followed by Legacy
4 IEEE 802.3af 2-Point only
5 IEEE 802.3af 2-Point followed by Legacy
NP2724M User Manual 42