NetComm NP2724M - Manual (Page 40)

Mode Interface Config
4.2) 8021 set
Status of local-802.1 settings
Format lldp tlvs-tx {enable | disable} option 8021 {pvid | vlanname |
protocol-id}
Mode Interface Config
eg.switch(interdface 1)lldp tlvs enable option 8021 pvid
4.3) 8023 set
Format lldp tlvs-tx {enable | disable} option 8023 {mac-phy | power|
link-aggregation| frame-size}
Mode Interface Config
4.4) MED-set
Status of MED Settings
Format lldp tlvs-tx {enable | disable} option med-set {capabilities | net-
policy | location-id | mdi}
Mode Interface Config
admin-mode
Configure administrative mode on a port
Format Switch(Interface 1)# admin-mode {enable | disable}
Mode Interface Config
auto-negotiate
Configure auto-negotiate mode on a port
Format auto-negotiate {enable | disable}
Mode Interface Config
speed
Set port speed to 10Mbps half duplex/ 10Mbps full/ 100Mbps half/ 100Mbps
full/ 1000Mbps 100FX mode/1000base-x full .
Format speed {10hd | 10fd | 100hd | 100fd | 1000fd | 100fx | 1000base-x}
Mode Interface Config
flow-control
This command enable/disable flow-control at port.
Format flow-control {enable | disable}
Mode Interface Config
port-security
1) port-security
This command add or delete a static mac into mac security table.
Format port-security {add|delete} <sourcemac >
Mode Interface Config
2) port-security lock-mode
This command disable port security or specify static lock mode.
Format port-security lock-mode {none | static}
Mode Interface Config
3) port-security lock-mode dynamic
This command enable limited dynamic lock mode,and specify maximin
learning entries for limited dynamic lock mode.the max-entries value :0~24
Format port-security lock-mode dynamic max-entries 24
NP2724M User Manual 39