NetComm NP2724M - Manual (Page 42)

Mode Interface Config
set igmp-router-port
This command specifies igmp router port .
Format set igmp-router-port {enable | disable}
Mode Interface Config
spanning tree
1) spanning-tree cost
This command configure RSTP port path cost, path cost
value:0~200000000.
Format spanning-tree cost <pathcost>
Mode Interface Config
2) spanning-tree edge
This command configure edge property
Format spanning-tree edge {enable|disable}
Mode Interface Config
e.g. Switch(Interface 1)# spanning-tree edge enable
3) spanning-tree force-p2plink
This command configure force point to point link mode.
Format spanning-tree force-p2plink {auto|enable|disable}
Mode Interface Config
4) spanning-tree migration-check
This command re-checks the appropriate BPDU format to send on this port
Format spanning-tree migration-check {enable|disable}
Mode Interface Config
5) spanning-tree mst
This command configures multiple spanning tree instance.
5.1) spanning-tree mst cost
This command configure the path cost on a MST
instance :1~200000000.
Format spanning-tree mst cost <pathcost>
Mode Interface Config
5.2) spanning-tree mst priority
This command configure the port priority on a MST instance:0~4096.
Format spanning-tree mst priority <1 4096>
Mode Interface Config
6) spanning-tree participation
This command configures RSTP capability on a port.
Format spanning-tree participation {enable|disable}
Mode Interface Config
7) spanning-tree priority
this command configure RSTP port priority:0~240
format spanning-tree priority <0..240>
mode Interface Config
vlan
1) vlan participation
This command join or leave a port to a vlan.
1.1) vlan participation exclude
This command leave a vlan.
NP2724M User Manual 41