National Instruments Measure Data Acquisition - Manual (Page 18)

Chapter 2 Getting Started with Data Acquisition Tasks
© National Instruments Corporation 2-5 Measure Data Acquisition User Manual
7. Click on the OK button to return to the DAQ Tasks dialog box,
shown in Figure 2-4. Notice that you now have a task named
Read Channel 0 in your task list. Notice also that the
description for this new task appears in the dialog box as well.
Figure 2-4. DAQ Tasks Dialog Box
8. Click on the Run button to execute the task. When the task
completes, there are 100 datapoints in column A of your
worksheet.
Configuring an Analog Output Task
If your DAQ device has analog output channels, you can use Measure
to generate analog output signals based on values in your spreadsheet.
Analog output tasks operate exactly opposite of analog input tasks.
You specify an area on your worksheet that contains data values, and
Measure converts these values to voltages and outputs them through an
analog output channel of your DAQ device. For more information on
analog output tasks, refer to Chapter 5, Analog Output Reference.