National Instruments Measure Data Acquisition - Manual (Page 65)

Appendix B Error Codes
Measure Data Acquisition User Manual B-12 © National Instruments Corporation
-10616 slaveClkErr The clock configuration for the clock
slave is invalid.
-10617 noClkSrcErr No source signal has been assigned to the
clock resource.
-10618 badClkSrcErr The specified source signal cannot be
assigned to the clock resource.
-10619 multClkSrcErr A source signal has already been
assigned to the clock resource.
-10620 noTrigErr No trigger signal has been assigned to
the trigger resource.
-10621 badTrigErr The specified trigger signal cannot be
assigned to the trigger resource.
-10622 preTrigErr The pretrigger mode is not supported or
is not available in the current
configuration, or no pretrigger source
has been assigned.
-10623 postTrigErr No posttrigger source has been assigned.
-10624 delayTrigErr The delayed trigger mode is not
supported or is not available in the
current configuration, or no delay source
has been assigned.
-10625 masterTrigErr The trigger configuration for the trigger
master is invalid.
-10626 slaveTrigErr The trigger configuration for the trigger
slave is invalid.
-10627 noTrigDrvErr No signal has been assigned to the
trigger resource.
-10628 multTrigDrvErr A signal has already been assigned to the
trigger resource.
-10629 invalidOpModeErr The specified operating mode is invalid,
or the resources have not been
configured for the specified operating
mode.
-10630 invalidReadErr An attempt was made to read 0-bytes
from the transfer buffer, or an attempt
was made to read past the end of the
transfer buffer.
-10631 noInfiniteModeErr Continuous input or output transfers are
not allowed in the current operating
mode.