National Instruments Measure Data Acquisition User Manual
Page 66
Appendix B Error Codes
© National Instruments Corporation
B-13
Measure Data Acquisition User Manual
-10632
someInputsIgnoredErr
Certain inputs were ignored because
they were not relevant in the current
operating mode.
-10633
invalidRegenModeErr
The specified analog output
regeneration mode is not allowed for
this device.
-10634
noContTransferInProgressE
rror
No continuous (double buffered)
transfer is in progress for the specified
resource.
-10635
invalidSCXIOpModeError
Either the SCXI operating mode
specified in a configuration call is
invalid, or a module is in the wrong
operating mode to execute the function
call.
-10636
noContWithSynchError
You cannot start a continuous (double-
buffered) operation with a
synchronous function call.
-10637
bufferAlreadyConfigError
Attempted to configure a buffer after
the buffer had already been
configured. You can configure a buffer
only once.
-10680
badChanGainErr
All channels of this device must have
the same gain.
-10681
badChanRangeErr
All channels of this device must have
the same range.
-10682
badChanPolarityErr
All channels of this device must have
the same polarity.
-10683
badChanCouplingErr
All channels of this device must have
the same coupling.
-10684
badChanInputModeErr
All channels of this device must have
the same input mode.
-10685
clkExceedsBrdsMaxConvRate
The clock rate exceeded the device’s
recommended maximum rate.
-10686
scanListInvalidErr
A configuration change has invalidated
the scan list.
-10687
bufferInvalidErr
A configuration change has invalidated
the allocated buffer.