National Instruments Measure Data Acquisition - Manual (Page 55)

Appendix B Error Codes
Measure Data Acquisition User Manual B-2 © National Instruments Corporation
-10010 badCountErr The count is too large or too small for
the specified counter, or the given I/O
transfer count is not appropriate for the
current buffer or channel configuration.
-10011 badIntervalErr The analog input scan rate is too fast for
the number of channels and the channel
clock rate, or the given clock rate is not
supported by the associated counter
channel or I/O channel.
-10012 badRangeErr The analog input or analog output
voltage range is invalid for the specified
channel.
-10013 badErrorCodeErr The driver returned an unrecognized or
unlisted error code.
-10014 groupTooLargeErr The group size is too large for the device.
-10015 badTimeLimitErr The time limit is invalid.
-10016 badReadCountErr The read count is invalid.
-10017 badReadModeErr The read mode is invalid.
-10018 badReadOffsetErr The offset is unreachable.
-10019 badClkFrequencyErr The frequency is invalid.
-10020 badTimebaseErr The timebase is invalid.
-10021 badLimitsErr The limits are beyond the range of the
device.
-10022 badWriteCountErr Possible reasons for this error are as
follows.
•
Your data array contains incomplete
update.
•
You are trying to write past the end
of the internal buffer.
•
Your output operation is continuous
and the length of your array is not a
multiple of one-half the internal
buffer size.
-10023 badWriteModeErr The write mode is out-of-range or is not
allowed.
-10024 badWriteOffsetErr Adding the write offset to the write mark
places the write mark outside the internal
buffer.
-10025 limitsOutOfRange The requested input limits exceed the
device's capability or configuration.
Alternative limits were selected.