National Instruments Measure Data Acquisition - Manual (Page 52)

Appendix A DAQ Hardware Capabilities
© National Instruments Corporation A-7 Measure Data Acquisition User Manual
SCXI-1141 8 DI ±5 1, 2, 5, 10, 20,
50, 100
(SW/C)
1
elliptic lowpass
filter with 10Hz
to 25KHz cutoff
frequency
2 (SW/M)1
(disabled on a per channel
basis)
— multiplexed
or parallel
1 DS/C = dip switch-selectable per channel, JS/C = jumper-selectable per channel, JS/M = jumper-selectable per
module, SW/C = software-selectable per channel, SW/M = software-selectable per module
2 The SCXI-1141 has an automatic filter setting. NI-DAQ sets the filter frequency based on the scan rates used with
the module.
Table A-10. Terminal Block Selection Guide—SCXI Modules
SCXI Module Terminal Blocks Cold-Junction
Compensation Sensor
(CJC)
SCXI-1100
SCXI-1102 SCXI-1303
SCXI-1300 Thermistor
IC Sensor
SCXI-1120
SCXI-1121 SCXI-1320
SCXI-1321
1
SCXI-1327
SCXI-1328
IC Sensor
IC Sensor
Thermistor
Thermistor
SCXI-1122 SCXI-1322 Thermistor
SCXI-1140 SCXI-1301
SCXI-1304 —
—
SCXI-1141 SCXI-1304 —
SCXI-1180 SCXI-1302
with NB1 cable —
SCXI-1181 SCXI-1300
SCXI-1301 IC Sensor
—
SCXI-1200 SCXI-1302
CB-50 with NB1 cable —
—
1 SCXI-1121 only