Nortel Networks 1000ASE-XD - Manual (Page 102)

102 Chapter 3 Using the console interface
209418-A
Reset Count A read-only field that indicates the number of resets since the operational firmware
was first loaded on the switch.
Default Value 1
Range 0 to 2 32 -1 (4,294,967,295)
Last Reset Type A read-only field that indicates the last type of reset.
Default Value Power Cycle
Range Power Cycle, Software Download, Management Reset,
Management Factory Reset
Power Status A read-only field that indicates the current power source (primary, RPSU, or both).
Default Value Primary Power
Range Primary Power, Redundant Power, Primary and Redundant
Power
Local GBIC Type A read-only field that indicates the GBIC type that is configured in this unit.
sysDescr A read-only field that specifies hardware and software versions.
sysObjectID A read-only field that provides a unique identification of the switch, which contains
the vendor’s private enterprise number.
sysUpTime A read-only field that shows the length of time since the last reset. Note that this field
is updated when the screen is redisplayed.
sysServices A read-only field that indicates the switch’s physical and data link layer functionality.
sysContact The name and phone number of the person responsible for the switch.
Default Value Zero-length string
Range Any ASCII string of up to 56 printable characters 1
sysName A name that uniquely identifies the switch.
Default Value Zero-length string
Range Any ASCII string of up to 56 printable characters 1
sysLocation The physical location of the switch.
Default Value Zero-length string
Range Any ASCII string of up to 56 printable characters
1 Although this field can be set to up to 255 characters from a Network Management Station (NMS), only 56 characters
are displayed on the console terminal.
Table 12 System Characteristics screen fields (continued)
Field Description