Nortel Networks 1000ASE-XD - Manual (Page 170)

170 Chapter 3 Using the console interface
209418-A
You can retrieve the configuration parameters of a standalone switch or an entire
stack and use the retrieved parameters to automatically configure a replacement
switch or stack. Certain requirements apply when automatically configuring a
switch or stack using this feature (see
“Requirements” on page 172 ). You must set
up the file on your TFTP server and set the filename read/write permission to
enabled before you can save the configuration parameters.
Although most configuration parameters are saved to the configuration file,
certain parameters are not saved (see
Table 41 on page 172 ).
To open the Configuration File Download/Upload screen:
Figure 77 Configuration File Download/Upload screen
Choose Configuration File (or press g) from the main menu.