Nortel Networks 1000ASE-XD - Manual (Page 91)

Chapter 3 Using the console interface 91
Using the BayStack 420 10/100/1000 Switch
Figure 40 Console interface main menu
Table 9 describes the CI main menu options.
Table 9 Console interface main menu options
Option Description
IP Configuration/
Setup... Displays the IP Configuration/Setup screen (see “IP Configuration/Setup screen”
on page 94 ). This screen allows you to set or modify IP configuration
parameters.
SNMP Configuration... Displays the SNMP Configuration screen (see “SNMP Configuration screen” on
page 99 ). This screen allows you to set or modify the SNMP read-only
community and read-write community strings, enable or disable the
authentication trap and the link Up/down trap, set the IP address of trap
receivers, and set the trap community strings.
System
Characteristics... Displays the System Characteristics screen (see “System Characteristics
screen” on page 100 ). This screen allows you to view switch characteristics,
including number of resets, power status, hardware and firmware version, and
MAC address. This screen also contains three user-configurable fields:
sysContact, sysName, and sysLocation. When the switch is part of a stack
configuration, this screen also displays the base unit identification, the number of
units configured in the stack, and the local unit stack number.