Nortel Networks Mediant TP-1610 SIP - Manual (Page 196)

Mediant 2000 SIP
Mediant 2000 SIP User’s Manual 196 Document #: LTRT-72504
To add a client to the list using a template, take these 5 steps:
1. Click on the Add New Client Icon;
a client with blank parameters is displayed.
2. In the field Template, located on the right side of the Client Configuration Window, click
on the down arrow to the right of the entry field and select the template that you want to use.
3. The values provided by the template are automatically entered into the parameter fields on
the right side of the Client Configuration Window. To use the template parameters, leave
the check box next to that parameter selected. The parameter values appear in gray text.
4. To change a parameter to a different value, unselect the check box to the right of that
parameter. This clears the parameter provided by the template and enables you to edit the
entry. Clicking the check box again restores the template settings.
5. Click Apply to save this entry to the list of clients or click Apply & Reset to save this entry to
the list of clients and send a reset message to that gateway to immediately implement the
settings.
Note:
To use Apply & Reset you must enable ARP Manipulation in the Preferences
window. Also, you must have administrator privileges for the computer you are using.
B.11.2 Deleting Clients
To delete a client from the BootP Tool, take these 3 steps:
1. Select the client that you wish to delete by clicking on the line in the window for that client.
2. Click the Delete Current Client button
3. A warning pops up. To delete the client, click Yes.
B.11.3 Editing Client Parameters
To edit the parameters for an existing client, take these 4 steps:
1. Select the client that you wish to edit by clicking on the line in the window for that client.
2. Parameters for that client display in the parameter fields on the right side of the window.
3. Make the changes required for each parameter.
4. Click Apply to save the changes, or click Apply & Reset to save the changes and send a
reset message to that gateway to immediately implement the settings.
Note:
To use Apply & Reset you must enable ARP Manipulation in the Preferences
window. Also, you must have administrator privileges for the computer you are using.
B.11.4 Testing the Client
There should only be one BootP utility supporting any particular client MAC active on the network
at any time.
To check if other BootP utilities support this client, take these 4 steps:
1. Select the client that you wish to test by clicking on the client name in the main area of the
Client Configuration Window
.
2. Click the Test Selected Client button
3. Examine the Log Window on the Main Application Screen. If there is another BootP utility
that supports this client MAC, there is a response indicated from that utility showing the
status Listed At along with the IP address of that utility.
4. If there is another utility responding to this client, you must remove that client from either this
utility or the other one.