Configuring the channel settings, Figure 5-16: channel settings screen, 2 configuring the channel settings – Nortel Networks Mediant TP-1610 SIP User Manual
Page 65
Mediant 2000 SIP User’s Manual
5. Web Management
Version 4.4
65
July 2005
5.9.2
Configuring the Channel Settings
The Channels Settings screen enables you to set the VoIP gateway channel parameters, such as
Input and Output voice gain, Jitter buffer characteristics, Modem, Fax and DTMF transport
modes. These parameters are applied to all Mediant 2000 channels.
Note that several Channels Settings parameters can be configured per call using profiles (refer to
Section
).
Note:
Channel parameters are changeable on-the-fly. Changes take effect from
next call.
To configure the Channel Settings parameters, take these 4 steps:
1.
Open the ‘Channel Settings’ screen (Advanced Configuration menu > Channel Settings);
the ‘Channel Settings’ screen is displayed.
2.
Configure the Channel Settings parameters.
3.
Click the Submit button to save your changes.
4.
To save the changes so they are available after a power fail, refer to Section
on page
84
.
Figure
5-16: Channel Settings Screen
Note 1:
The parameters ‘MF Transport Type’ and the 5 Answer Detector parameters
are not applicable to the Mediant 2000.
Note 2:
The parameters ‘DTMF Transport Type’ and ‘Fax Transport Mode’ are
overridden by the parameters ‘IsDTMFUsed’ and ‘IsFaxUsed’ respectively.