Nortel Networks Mediant TP-1610 SIP - Manual (Page 90)

Mediant 2000 SIP
Mediant 2000 SIP User’s Manual 90 Document #: LTRT-72504
6.6 Basic, Logging, Web and RADIUS Parameters
Note: In Table 6-1 , parameters in brackets are the format in the Embedded Web
Server * .
Table 6-1: Basic, Logging, Web and RADIUS Parameters (continues on pages 90 to 97)
ini File Field Name
Web Parameter Name
*
Valid Range and Description
EthernetPhyConfiguration 0 = 10 Base-T half-duplex
1 = 10 Base-T full-duplex
2 = 100 Base-TX half-duplex
3 = 100 Base-TX full-duplex
4 = auto-negotiate (Default)
Auto-negotiate falls back to half-duplex mode (HD) when the opposite port is not in
auto-negotiate, but the speed (10 Base-T, 100 Base -TX) in this mode is always
configured correctly.
DHCPEnable
[Enable DHCP] 0 = Disable DHCP support on the gateway (default).
1 = Enable DHCP support on the gateway.
After the gateway is powered up, it attempts to communicate with a BootP server. If a
BootP server is not responding and if DHCP is enabled, then the gateway attempts to
get its IP address and other network parameters from the DHCP server.
Web Note:
After you enable the DHCP Server (from the Web browser) follow this
procedure:
• Click the Submit button.
• Save the configuration using the ‘Save Configuration’ button (before you reset
the gateway). For information on how to save the configuration, refer to Section
5.12 on page 84 .
• Reset the gateway directly (Web reset doesn’t trigger the BootP/DHCP
procedure and the parameter DHCPEnable reverts to ‘0’).
Note that throughout the DHCP procedure the BootP/TFTP application must be
deactivated. Otherwise, the gateway receives a response from the BootP server
instead of the DHCP server.
Note:
The DHCPEnable is a special "Hidden" parameter. Once defined and saved in
flash memory, its assigned value doesn’t revert to its default even if the parameter
doesn't appear in the ini file.
EnableDiagnostics 0 = No diagnostics (default)
1 = Perform diagnostics
EnableLanWatchDog
[Enable LAN Watchdog] 0 = Disable LAN Watch-Dog (default).
1 = Enable LAN Watch-Dog.
If LAN Watch-Dog is enabled, the gateway restarts when a network failure is
detected.
DNSPriServerIP
[DNS Primary Server IP]
IP address of the primary DNS server in dotted format notation.
DNSSecServerIP
[DNS Secondary Server IP]
IP address of the secondary DNS server in dotted format notation.