Nortel Networks Mediant TP-1610 SIP - Manual (Page 98)

Mediant 2000 SIP
Mediant 2000 SIP User’s Manual 98 Document #: LTRT-72504
6.7 SNMP Parameters
Note: In Table 6-2 , parameters in brackets are the format in the Embedded Web
Server
*
.
Table 6-2: SNMP Parameter (continues on pages 98 to 99)
ini File Field Name
Web Parameter Name
*
Valid Range and Description
DisableSNMP
[Enable SNMP] 0 = SNMP is enabled (default).
1 = SNMP is disabled and no traps are sent.
SNMPPort The device’s local UDP port used for SNMP Get/Set commands.
The range is 100 to 3999.
The default port is 161.
SNMPTrustedMGR_x Up to five IP addresses of remote trusted SNMP managers from which the
SNMP agent accepts and processes get and set requests.
Note 1:
If no values are assigned to these parameters any manager can
access the device.
Note 2:
Trusted managers can work with all community strings.
SNMP Trap Parameters
SNMPManagerTableIP_x
[SNMP Managers Table] Up to five IP addresses of remote hosts that are used as SNMP Managers. The
device sends SNMP traps to these IP addresses.
Enter the IP address in dotted format notation, for example 108.10.1.255.
Note:
The first entry (out of the five) replaces the obsolete parameter
SNMPManagerIP.
SNMPManagerTrapPort_x
[SNMP Managers Table] Up to five parameters used to define the Port numbers of the remote SNMP
Managers. The device sends SNMP traps to these ports.
Note:
The first entry (out of the five) replaces the obsolete parameter
SNMPTrapPort.
The default SNMP trap port is 162
The SNMP trap port must be between 100 to 4000.
SNMPManagerIsUsed_x
[SNMP Managers Table] Up to five parameters, each determines the validity of the parameters (IP
address and port number) of the corresponding SNMP Manager used to
receive SNMP traps.
0 = Disabled (default)
1 = Enabled
SNMPManagerTrapSendingEnable_x
[SNMP Managers Table] Up to five parameters, each determines the activation/deactivation of sending
traps to the corresponding SNMP Manager.
0 = Sending is disabled
1 = Sending is enabled (default)
SNMPManagerIP
Note:
Obsolete parameter, use
SNMPManagerTableIP_x instead.
IP address (in dotted format notation) for the computer that is used as the first
SNMP Manager. The SNMP Manager is a device that is used for receiving
SNMP Traps.
Note 1:
To enable the device to send SNMP Traps, set the ini file parameter
SNMPManagerIsUsed to 1.
Note 2:
If you want to use more than one SNMP manger, ignore this parameter
and use the parameters ‘SNMPManagerTableIP_x’ instead.
SNMP Community String Parameters
SNMPReadOnlyCommunityString_x Read-only community string (up to 19 chars).
The default string is “public”.
SNMPReadWriteCommunityString_x Read-write community string (up to 19 chars).
The default string is “private”.
SNMPTrapCommunityString_x Community string used in traps (up to 19 chars).
The default string is “trapuser”.