Rtsi, Cables, Custom cabling and connectivity – National Instruments DAQ M Series User Manual
Page 129
Appendix A
NI 6236 Device Information
A-4
ni.com
RTSI
Use RTSI bus cables to connect timing and synchronization signals among
PCI devices, such as M Series, E Series, CAN, and other measurement,
vision, and motion devices. Since PXI devices use PXI backplane signals
for timing and synchronization, no cables are required.
Cables
In most applications, you can use the following cables:
•
DB37M-DB37F-EP—37-pin male-to-female twisted-pair shielded
I/O cable
•
SH37F-37M-x—37-pin female-to-male shielded I/O cable, UL Listed
derated to 30 Vrms, 42.4 V
pk
, or 60 VDC
•
R37F-37M-1—37-pin female-to-male ribbon I/O cable
•
SH37F-P-4—37-pin female-to-pigtails shielded I/O cable
Custom Cabling and Connectivity
Refer to the
section of Chapter 2,
,
for more information about custom cabling solutions.