National Instruments DAQ M Series User Manual
Page 151
Glossary
© National Instruments Corporation
G-17
software triggering
A method of triggering in which you simulate an analog trigger using
software. Also called conditional retrieval.
source impedance
A parameter of signal sources that reflects current-driving ability of voltage
sources (lower is better) and the voltage-driving ability of current sources
(higher is better).
synchronous
1. Hardware—A property of an event that is synchronized to a reference
clock.
2. Software—A property of a function that begins an operation and
returns only when the operation is complete. A synchronous process is,
therefore, locked and no other processes can run during this time.
T
task
In NI-DAQmx, a collection of one or more channels, timing, and triggering
and other properties that apply to the task itself. Conceptually, a task
represents a measurement or generation you want to perform.
TC See terminal count.
terminal
An object or region on a node through which data passes.
terminal count
The highest value of a counter.
t
gh
Gate hold time.
t
gsu
Gate setup time.
t
gw
Gate pulse width.
Timebase
The reference signals for controlling the basic accuracy of time or
frequency-based measurements. For instruments, timebase refers to the
accuracy of the internal clock.
t
out
Output delay time.
transducer
A device that responds to a physical stimulus (heat, light, sound, pressure,
motion, flow, and so on), and produces a corresponding electrical signal.
See also