Nortel Networks NN44200-313 - Manual (Page 29)

Enabling card slots (LD 32) 29
Prompt Response Notes
KEY 0 SCR xxxx Where xxxx is the line number
of the telephone. This is the
number dialled or the line
selected when the user makes
a call from the telephone.
For example:
4710
KEY 16 MWK xxxx Where xxxx is the CDN of the
CallPilot system.
For example:
4300
4 Repeat step 3 for each telephone to be configured.
Configure at least two telephones for testing purposes.
5 To exit the overlay, enter ****.
6 Connect two telephones to either a phone line or a proper network
connection, depending on the telephone type. Refer to the user
guides specific to the telephones.
7 Ensure that you have dial tone on both telephones, and check that
you can dial one phone from the other.
—End—
Enabling card slots (LD 32)
If the MGATE card slots are not automatically provisioned, perform the
following procedure to enable them.
Step Action
1 Connect to the PBX.
2 Enter LD 32.
3 To display the status of the MGATE card, enter STAT n (where n is
the card slot used by the MGATE).
For example: STAT 18.
4 If the MGATE card is disabled, enter ENLC n (where n is the card
slot used by the MGATE) to enable it.
For example: ENLC 18.
5 Repeat steps 3 and 4 for each required MGATE card.
Nortel CallPilot
Quickstart Guide
NN44200-313 01.02 Standard
5.0 19 May 2008
Copyright © 2007-2008, Nortel Networks
.