Running the configuration wizard – Nortel Networks NN44200-313 User Manual
Page 49
Running the Configuration Wizard
49
Running the Configuration Wizard
This procedure covers basic provisioning only. You can perform additional
provisioning and advanced configuration, such as media allocation,
channels, CDNs, and languages, after completing the basic provisioning
steps in this procedure. Alternatively, you can run the Configuration Wizard
at any time to make configuration changes or add additional information.
Additional provisioning and advanced configuration adds time to the
installation.
Step
Action
1
If CallPilot Manager is not already open in Internet Explorer, type
http://localhost/cpmgr in the address bar.
2
Log on to CallPilot Manager using the following default credentials:
•
Mailbox number: 000000
•
Password: 124578
•
Server: localhost
•
Location: leave this field blank
3
Click Login.
4
When prompted, change the default administrator password for
mailbox 000000 as follows:
a. Type the current password, 124578.
b. Type a new password.
c. Type the new password again.
5
On the Welcome to CallPilot Manager page, click Configuration
Wizard.
6
On the Configuration Wizard: Welcome page, click Next.
7
On the Keycode and serial number page, do the following:
a. Type the Serial number assigned to the USB dongle that is
plugged into the CallPilot system.
b. Type the Keycode assigned to the CallPilot register from the
dongle.
c. Click Next.
8
On the Feature Verification page, review the parameters to ensure
they are correct, and then click Next.
9
On the Server Information page, do the following:
Nortel CallPilot
Quickstart Guide
NN44200-313
01.02
Standard
5.0
19 May 2008
Copyright © 2007-2008, Nortel Networks
.