Nortel Networks NN44200-313 - Manual (Page 58)

58 CallPilot server testing
Step Action
1 Log on to CallPilot Manager on the local console.
2 In the CallPilot Manager toolbar, select Maintenance > Channel
Monitor.
3 From both test telephones, simultaneously dial the CallPilot voice
messaging CDN.
Call from one test telephone and leave it off the hook while you dial
from the other, so that both channels are occupied at the same
time. If you have other channels that require testing, stop all other
channels except the ones being tested.
4 In CallPilot Manager, observe the channel status of both channels
change from dark blue to light blue, indicating the channels are in
an active state.
5 Hang up both telephones and observe both channels. The channels
change from light blue to dark blue, indicating they are in idle mode
waiting for a call.
—End—
Testing pcAnywhere using a remote PC
Perform the following procedure to test pcAnywhere using a remote PC.
This procedure requires a PC with modem, a connected telephone line, and
the pcAnywhere client installed. pcAnywhere is preinstalled with one license
on the CallPilot server but requires a separate client license and software.
Nortel does not include a copy for client installation.
Step Action
1 Configure your client pcAnywhere using the dialing information of
the telephone line connected to the CallPilot server modem.
2 Start pcAnywhere and connect to the CallPilot server through the
remote PC.
3 Log on to the CallPilot server.
4 Check that you have full remote control of the system.
5 Disconnect the pcAnywhere client.
—End—
Nortel CallPilot
Quickstart Guide
NN44200-313 01.02 Standard
5.0 19 May 2008
Copyright © 2007-2008, Nortel Networks
.