Nortel Networks NN44200-313 - Manual (Page 51)

Running the Configuration Wizard 51
a. In the CND box, type the CDN configured in the procedure
"Configuring the CDN queue (LD 23)" (page 25) .
b. From the Application Name list, select Voice Messaging.
c. Click OK.
15 In the CND Information page, click Next.
16 Insert the CallPilot 5.0 Language CD into the DVD drive.
17 In the Language Source Directory page, do the following:
a. Select the Install Language option.
b. In the Language CD Location box, type Z:.
c. Click Next.
18 In the Language Installation page, do the following:
a. Select languages and automated speech recognition to be
installed.
b. Select the Primary and, optionally, Secondary languages to
install.
c. Click Next.
19 In the CallPilot Local Area Network Interface page, do the
following:
a. For Equipment LAN network interface card, select ELAN.
b. For IP address, type the IP address assigned to the ELAN NIC.
c. For Subnet Mask, type the network subnet mask assigned to
the ELAN NIC.
d. For Customer LAN network interface card, select CLAN.
e. For IP address, type the IP address assigned to the CLAN NIC.
f. For Subnet Mask, type the subnet mask assigned to the CLAN
NIC.
g. For Gateway, type the gateway assigned to the CLAN NIC.
h. Click Next.
20 In the Ready to Configure page, click Finish, and then wait for
the configuration to be applied.
Note: With two languages installed, the configuration process
takes approximately 20 minutes to complete. Each language
prompt installed adds approximately 10 minutes to the
configuration process.
Nortel CallPilot
Quickstart Guide
NN44200-313 01.02 Standard
5.0 19 May 2008
Copyright © 2007-2008, Nortel Networks
.