National Instruments VXI-MIO Series User Manual
Page 145
Index
National Instruments Corporation
I -5
VXI-MIO Series User Manual
H
hardware installation, 2-8 to 2-9
hardware overview
analog input, 3-3 to 3-9
considerations for selecting input
ranges, 3-6
dither, 3-7 to 3-8
input modes, 3-3 to 3-4
input polarity and range, 3-4 to 3-6
multichannel scanning
considerations, 3-8 to 3-9
analog output, 3-10 to 3-11
output polarity selection,
3-10 to 3-11
reference selection, 3-10
reglitch selection, 3-11
analog trigger, 3-11 to 3-14
above-high-level analog triggering
mode (figure), 3-13
below-low-level analog triggering
mode (figure), 3-12
block diagram, 3-12
high-hysteresis analog triggering
mode (figure), 3-13
inside-region analog triggering mode
(figure), 3-13
low-hysteresis analog triggering
mode (figure), 3-14
digital I/O, 3-14
timing signal routing, 3-15 to 3-16
CONVERT* signal routing
(figure), 3-15
programmable function inputs, 3-16
VXIbus triggers, 3-17
I
input characteristics
VXI-MIO-64E-1, A-1 to A-2
VXI-MIO-64XE-10, A-10
input configurations, 4-12 to 4-20
available input modes, 3-3 to 3-4
DIFF (table), 3-3
NRSE (table), 3-3
RSE (table), 3-3
common-mode signal rejection, 4-20
differential connections
DIFF input configuration, 4-14
floating signal sources, 4-16 to 4-17
ground-referenced signal
sources, 4-15
nonreferenced signal sources,
4-16 to 4-17
recommended configuration
(figure), 4-13
single-ended connections, 4-18 to 4-20
floating signal sources (RSE
configuration), 4-19
grounded signal sources (NRSE
configuration), 4-19 to 4-20
input polarity and range, 3-4 to 3-6
mixing bipolar and unipolar channels
(note), 3-5
selection considerations, 3-6
VXI-MIO-64E-1, 3-4 to 3-5
actual range and measurement
precision (table), 3-4 to 3-5
VXI-MIO-64XE-10, 3-5 to 3-6
actual range and measurement
precision (table), 3-6
installation.
See also
configuration.
common questions about, C-2
hardware installation, 2-8 to 2-9
software installation, 2-9 to 2-10
unpacking VXI-MIO series boards, 1-6
I/O connectors, 4-1 to 4-9
exceeding maximum ratings
(warning), 4-1
optional cable connectors
68-pin extended analog input
connector pin assignments
(figure), B-3
68-pin MIO connector pin
assignments (figure), B-2
pin assignments (figure), 4-2
signal descriptions (table), 4-3 to 4-5