National Instruments VXI-MIO Series User Manual
Page 147
Index
National Instruments Corporation
I -7
VXI-MIO Series User Manual
common-mode signal rejection, 4-20
differential connections
floating signal sources, 4-16 to 4-17
ground-referenced signal
sources, 4-15
single-ended connections
floating signal sources (figure), 4-19
grounded signal sources
(figure), 4-20
physical specifications
VXI-MIO-64E-1, A-9
VXI-MIO-64XE-10, A-16
pin assignments.
See
I/O connectors.
polarity
input polarity and range, 3-4 to 3-6
output polarity selection, 3-10 to 3-11
posttriggered data acquisition, 4-25
illustration, 4-25
power connections, 4-23
power requirement specifications
VXI-MIO-64E-1, A-9
VXI-MIO-64XE-10, A-16
pretriggered data acquisition, 4-25
illustration, 4-26
programmable function inputs (PFIs).
See
PFIs (programmable function inputs).
programmable gain instrumentation amplifier.
See
PGIA (programmable gain
instrumentation amplifier).
Q
questions about VXI-MIO series, C-1 to C-6
analog input and analog output,
C-2 to C-4
general information, C-1 to C-2
installation and configuration, C-2
timing and digital I/O, C-4 to C-6
R
reference selection, analog output, 3-10
referenced single-ended input (RSE).
See
RSE
(referenced single-ended input).
reglitch selection, 3-11
RSE (referenced single-ended input)
description (table), 3-3
recommended configuration
(figure), 4-13
single-ended connections for floating
signal sources, 4-19
S
SCANCLK signal
description (table), 4-4
timing connections, 4-26
VXI-MIO-64E-1 (table), 4-6
VXI-MIO-64XE-10 (table), 4-8
settling time, 3-9
signal connections
analog input, 4-9 to 4-20
analog output, 4-20 to 4-21
digital I/O, 4-22 to 4-23
field wiring considerations, 4-45
input configurations, 4-12 to 4-20
common-mode signal rejection, 4-20
differential connections
DIFF input configuration, 4-14
floating signal sources,
4-16 to 4-17
ground-referenced signal
sources, 4-15
nonreferenced signal sources,
4-16 to 4-17
recommended configuration
(figure), 4-13
single-ended connections, 4-18 to 4-20
floating signal sources (RSE
configuration), 4-19
grounded signal sources (NRSE
configuration), 4-19 to 4-20
I/O connector, 4-1 to 4-9
exceeding maximum ratings
(warning), 4-1
pin assignments (figure), 4-2
signal descriptions (table),