Figure 2-2, Scxi-1121 detailed parts locator diagram -3 – National Instruments SCXI-1121 User Manual
Page 18
Chapter 2
Configuration and Installation
2-2
www.natinst.com
Figure 2-2. SCXI-1121 Detailed Parts Locator Diagram
The jumpers are used as follows:
•
Fixed jumpers
–
On Revision A and B modules, jumper W32 is unused and should
not be connected.
–
Jumper W45 is reserved and should not be reconfigured.
–
On Revision A and B modules, jumper W44 carries the
SLOT0SEL* signal from the rear signal connector, after
buffering, to the SCXIbus INTR* line and should be left in the
factory-set position (position 1). On Revision C or later modules,
jumper W44 does not exist.
•
User-configurable jumpers
–
Jumper W38 carries the SCXIbus MISO line, after buffering, to
the SERDATOUT signal on the rear signal connector.
–
On Revision C or later modules, jumper W32 connects a pullup
resistor to the SERDATOUT signal on the rear signal connector.
–
Jumper W33 configures the guard, the analog output ground, and
enables the Pseudodifferential Reference mode.