NEC VisuaLink 128/384 - Manual (Page 72)

Page 5-14 NDA-24230 Issue 2.0
Chapter 5 VisuaLink 128/384 User Guide
The setting screen is displayed. The current setting is displayed.
Note 1: To select an item use the up and down portion of the CAMERA
CONTROL button.
Note 2: To change a setting use the left and right portion of the CAMERA
CONTROL button to toggle through the item.
➂ Press ENTER button to define it after changing a setting.
➃ Press the MENU or CANCEL button three (3) times to proceed back to the
video image.
Speed : < 128Kb/s >
Incoming mode : < Select >
Number of rings : <1>
Restricted dial No. : [2222]
Call restriction
: < No limit >
Register speed dial : < Allowed >
Press ENTER after choosing.
Speed: Sets the default transmission rate. What ever rate is set,
this is the rate shown in the dialing screen.
Incoming mode: Sets the incoming call mode. Posible settings are:
Auto - automatically answers the call.
Manual - the user must answer the call with the remote.
Select - Only answers calls that are stored in the speed
dial.
Number of rings: The number of rings required before the system answers
the call.
Restricted dial No.: Allows the user to set caller restriction number.
Call restriction: Allows the user to set a call restriction. Possible settings
are:
No limit - the user can place calls with no restrictions.
Speed dial only - the user can only place calls that are
stored in the speed dial register.
Manual dial inhibited - the user cannot place manual
calls.
Register speed dial: Allows the user to set access level for speed dial
registrations. Possible settings are:
Allowed - allows the user the access to set speed dial.
Disabled - the user is not allowed to access the speed dial
registration.
▲