NEC VisuaLink 128/384 User Manual
Page 92
Page 6-2
NDA-24230 Issue 2.0
Chapter 6
VisuaLink 128/384 User Guide
Checking Operation
Verify that local and remote sites are able to be seen and heard at the remote ends.
Verify that a control from the remote controller is normal by referring to
If unable to connect to the remote site it maybe because the remote site is busy,
wait and then repeat the above operation. If the operation persist, proceed to
➂ Enter the first telephone number using the NUMBER buttons,.
Note 1: When pressing down side on CAMERA CONTROL button after the
first number is completed, the number is copied to PHONE NUMBER 2.
This is done because typically when dialing two (2) BRI numbers, the
PHONE NUMBER 2 number sometimes exactly match or is similar to
the first number.
Note 2: At any time you may press the CALL button and ENTER button. This
will immediately place a video call to the far-end.
Place Manual Dial Call
Phone Number 1
[
]
Phone Number 2
[
]
Speed
: <128kb/s>
Press ENTER or CALL after entering
Press CANCEL to go to Call Screen
▲
ENTER
NUMBER