Ricoh Aficio Copy Machine 180 - Manual (Page 273)

NetWare Configuration
38
3
NetWare 4.x, 5 - Advanced Settings
The actual procedures for configuring your printer differ depending on whether
the Network Interface Board is configured as a print server or as a remote print-
er. This section describes how to configure it in the NetWare 4.x, 5 environment.
❖ To use NetWare 5
• Load the IPX protocol into the file server in advance.
• You cannot use the NDPS (Novell Distributed Print Services) mode.
Preparation
The following procedures use the Property Sheet method in configuring the
Network Interface Board. If you configure the Network Interface Board as a
NetWare print server for the first time after physically installing it, we recom-
mend you use the Wizard method. For more information, refer toP.29 “Quick
Setup Using the NIB Setup Tool Wizard”.
Note
❒ This section assumes NetWare is functional and that the necessary environ-
ment for the NetWare Print Service is available.
❒ You should install the client software released from Novell on the Windows
before running the NWAdmin.
Setting Up as Print Server
Important
❒ You can set up the print server using the NDS or Bindery mode in NetWare
4.x, 5. The following procedure is for setting up the print server using the
NDS mode in NetWare 4.1. When you set up the print server using the Bind-
Installing the NIB Setup Tool
Print Server Remote Printer
Basic Procedure
Configuring the Network Interface Board
Configuring the NetWare
Turning the power
off and on Start the print server