Problems when using the pcr-1, P. 111, Operating system becomes unstable – Roland PCR-1 User Manual
Page 111: Can’t hear sound from the computer
111
Troubleshooting
Problems when using the PCR-1
fig.winmac
Operating system becomes unstable
•
Operation becomes unstable when the computer is started up with the PCR-1 already
connected
Please start up your computer with the PCR-1 disconnected, and then connect the PCR-1. On a
computer that uses a USB keyboard, starting up the computer with the PCR-1 already connected
may cause operation to become unstable. In this case, start up the computer with the PCR-1
disconnected, and then connect the PCR-1.
fig.winmac
Can’t hear sound from the computer
•
Do the recording and playback sampling frequencies match?
Set the recording and playback sampling frequencies so they match.
•
The PCR-1’s Sampling frequency select switch may have been set to “96 kHz REC”.
With this setting, only recording is possible. Sound from the computer cannot be played back.
•
In your playback software, have you specified the audio data output destination?
For some software, such as Cool Edit Pro LE, you will need to specify the
PCR-1
as the output
destination for audio data. For details on the procedure for making settings, refer to the owner’s
manual for your software.
•
Are you running multiple applications?
If multiple applications are running simultaneously, an error message may appear. If this occurs,
click
[OK]
and exit the other applications.
Even if an application window is closed, it is still running if it appears in the taskbar. Be sure to exit
unneeded applications displayed.
•
Was the driver installed correctly?
In order for you to play back audio data via the PCR-1, the driver must be installed. For installation
and settings, refer to
“Getting Connected and Installing Drivers”
(
➝
Windows
Macintosh
•
Is your computer in Suspend or Sleep mode?
If so, get your computer to resume normal operation, then exit all applications that are using the
PCR-1. Next, turn the PCR-1’s power off, then switch it on again.
•
Did you plug in the USB cable, or unplug it while an application was running?
Exit all applications that are using the PCR-1, and exit all applications that are using the PCR-1, and
re-connect the PCR-1.
•
Have you selected “Game compatible device” or “Voice modem” as the output for the
audio track?
If game compatible device or voice modem (the actual name will depend on the computer you are
using) is selected for the audio track of your software, the audio track may not play back. Do not
select these devices as the port.
fig.winmac
Volume from a device connected to the input jacks is too low
•
Are you using a cable that has a built-in resistor?
Use a cable without a built-in resistor (e.g., Roland PCS series).
•
Is the Input volume raised appropriately?
Turn the knob clockwise to adjust the volume.
PCR-1_e1.book 111 ページ ２００３年１１月２０日 木曜日 午後３時２２分