Roland PCR-1 - Manual (Page 37)

37
Getting Connected and Installing Drivers (Macintosh)
5
From the File menu, choose Open .
6
Select PCR-1 from the FreeMIDI Setting folder you copied in step 3 , and
click [Open] .
7
Verify that MIDI transmission and reception occur correctly.
From the MIDI menu, choose Check Connections .
fig.FreeMIDI_40
8
Try moving the fader of the PCR-1.
If the number
1 or 2 in the diagram
at right blinks, the settings have
been made correctly.
9
Once again choose the MIDI menu command Check Connections to end
the test.
10
From the File menu, choose Quit to exit FreeMIDI Setup .
If you are unable to select
Open
, make settings as
follows.
1.From the File menu,
choose FreeMIDI
Preference
.
2.Uncheck “Use OMS
when available.”
3. Close FreeMIDI.
4. Return to step 4 and
continue the procedure.
For details on the PCR-1’s
input/output devices,
refer to Input / output
devices
(p. 44).
This completes installation of the driver.
Next, make MIDI device settings in your sequencer or other software.
For details on how to make these settings, refer to the owner’s manual for your software.
For details on the PCR-1’s input/output devices, refer to Input / output devices (p. 44).
PCR-1_e1.book 37 ページ ２００３年１１月２０日 木曜日 午後３時２２分