Roland PCR-1 - Manual (Page 47)

47
Use audio functionality
Recording sound on your computer
(using your
application to record sound from external audio device)
fig.PCrec
Setting
• Use the Input volume (p. 12) to adjust the input level.Check the input level on the application
that you using.
• You must set the PCR-1’s sample rate to match the sampling frequency used by your
application.( ➝ USB AUDIO MODE SETTING (p. 96))
In order for the sampling frequency setting to take effect, you exit applications and disconnect
the USB cable from the PCR-1, then connect it again.
• If Direct Monitor (p. 97) is ON, the signal input through the audio input jacks will be output
from the headphone jack and the master output jacks. is ON, use the Master volume knob (p.
9) to adjust the monitor level.
* Adjusting the monitor level will not change the recording level.
USB Cable
Signal flow
Audio Cable
MIDI
Sound
Module
Audio amp
(cassette deck)
OUTPUT Connect to INPUT L-R
Record Player
Adjust the
input level.
PCR-1_e1.book 47 ページ ２００３年１１月２０日 木曜日 午後３時２２分