Roland PCR-1 - Manual (Page 34)

34
Getting Connected and Installing Drivers (Macintosh)
■
Setting the driver
If you are using FreeMIDI, proceed to FreeMIDI settings (p. 36).
OMS settings
1
Use the USB cable to connect the PCR-1 to your computer .
fig.3-3
2
From the CD-ROM, drag the Driver E (Mac OS 9) - OMS
Setting folder into the Opcode - OMS Applications
folder on the hard disk of your Macintosh to copy it there.
fig.3-4
3
In the Opcode - OMS Applications folder where you
installed OMS, double-click OMS Setup to start it up.
fig.3-5_35
4
If a dialog box like the one shown
here appears, click
[Turn It Off] . A
confirmation dialog box will then
appear, so click [OK] .
fig.3-6_35
5
The Create a New Studio Setup
dialog box will appear. Click
[Cancel] .
If you accidentally clicked [OK] , click
[Cancel] in the next screen.
This unit is equipped with
a protection circuit. A brief
interval (a few seconds)
after connecting the USB
cable is required before the
unit will operate normally.
If you are using the PCR-1
in conjunction with other
MIDI devices, make
settings as described in
Readme_E.htm
located in
the Driver E (Mac OS 9)
folder of the CD-ROM.
We recommend that you
turn off AppleTalk, by
selecting Chooser from the
Apple menu.
PCR-1_e1.book 34 ページ ２００３年１１月２０日 木曜日 午後３時２２分