Roland PCR-1 - Manual (Page 83)

83
Use MIDI functionality
Master Volume
F0 7F 7F 04 01 vL vM F7
Since a Master Volume message has a data range of 00 00–7F 7F and we do not need to specify
the range, we will use
Basic mode . Since the two bytes of data are in the order of LSB and then
MSB, we will select “DT3” (p. 80) when we input the data.
1. Press the [EDIT] button.
The display will indicate “EDT”.
2. Slightly move the controller to which you want to assign the system exclusive message. In
the case of a button, press that button.
The display will indicate the number of the selected controller.
3. Confirm what’s indicated, and press the [ENTER] button.
4. Press an ASSIGNABLE FUNCTION key ( ) on the keyboard enough times to get
"SE0" to appear in the display.
5. Confirm what’s indicated, and press the [ENTER] button.
The display will indicate “F0,” which is the first byte (beginning status) of a system
exclusive message. (This cannot be changed.)
6. Confirm what’s indicated, and press the [ENTER] button.
7. Use the [7] and [F] keys to input the second byte “7F”.
8. Confirm what’s indicated, and press the [ENTER] button.
Input the third, fourth and fifth bytes in the same way.
9. Since the sixth byte is the data area, press the [DATA] key, and then press [3] .
The display will indicate “DT3”.
10. Confirm what’s indicated, and press the [ENTER] button.
11. Since we selected “DT3” as the sixth byte, the seventh byte will automatically be allocated
as the data area and cannot be modified.
12. Confirm what’s indicated, and press the [ENTER] button.
13. Use the [F] and [7] keys to input the ending status byte “F7”.
14. Confirm what’s indicated, and press the [ENTER] button.
15. Specify the output port. ( ➝ Specifying the port (p. 62))
16. If you are making an assignment for a button, specify the button mode. ( ➝
Specifying the
button mode (p. 62))
The Master Volume message has now been assigned.
PCR-1_e1.book 83 ページ ２００３年１１月２０日 木曜日 午後３時２２分