Omnitron Systems Technology iConverter 10/100M - Manual (Page 30)

4.3.3 SFP Information
The 10/100M module installed with an SFP will provide general and specific information on the SFP. This
information is best viewed with SNMP management software. The following is the information available:
4.3.3.1 SFP A0 Information Display
This section displays fixed SFP Module information for the following areas.
• Identifier Values • Extended Identifier
• Connector Values • Transceiver Codes
• Encoding Rules • Normal Bit Rate
• Link Length • Vendor Name
• Vendor OUI • Vendor Revision Number
• Laser Wavelength • Options
• Vendor Serial Number • Date Code
• Diagnostic Monitoring Type • Enhanced Options
• SFF-8472 Compliance
4.3.3.2 SFP A2 Information Display
This section displays decoded SFP data collected for the following statistics.
• Measured Temperature • Measured Vcc
• Measured Bias • Measured Tx Power
• Measured Rx Power • Temperature High Alarm Setting
• Temperature Low Alarm Setting • Temperature High Warning Setting
• Temperature Low Warning Setting • Vcc High Alarm Setting
• Vcc Low Alarm Setting • Vcc High Warning Setting
• Vcc Low Warning Setting • Bias High Alarm Setting
• Bias Low Alarm Setting • Bias High Warning Setting
• Bias Low Warning Setting • Tx Power High Alarm Setting
• Tx Power Low Alarm Setting • Tx Power High Warning Setting
• Tx Power Low Warning Setting • Rx Power High Alarm Setting
• Rx Power Low Alarm Setting • Rx Power High Warning Setting
• Rx Power Low Warning Setting
Page 30