Omnitron Systems Technology iConverter 10/100M - Manual (Page 7)

the “Off” position (factory default) forces the port to negotiate to No Pause mode with its link partner.
Setting the Pause DIP-switch to the “On” position allows the port to negotiate to Symmetrical Pause, or No
Pause mode with its link partner.
When a port is operating in Manual mode, its Pause operation mode is based on the Pause Disable/Enable
DIP-switch setting. Setting the Pause DIP-switch to the “Off” position (factory default) forces the port to
operate in No Pause mode. Setting the Pause DIP-switch to the “On” position allows the port to operate in
Symmetrical Pause mode.
3.2.1.2 SW2 - Fiber Full/Half-Duplex “FDX/HDX”
When the DIP-switch is in the Full Duplex “FDX” position (factory default), the fiber port will facilitate a
connection that supports Full-Duplex operation. Setting this DIP-switch to Half-Duplex “HDX” facilitates
a connection that supports only Half-Duplex.
3.2.1.3 SW3 - UTP Auto/Manual Negotiate “AN/Man”
When the DIP-switch is in the UTP auto-negotiate “AN” position (factory default), the UTP port automatically
determines the speed and duplex mode of the connecting UTP device. If the connecting UTP device cannot
provide the proper signal to indicate its own mode of operation, this DIP-switch should be set to the UTP
Manual mode “Man” position. Manual mode requires manually configuring the UTP port to match the
speed and the duplex mode of the connecting UTP device using the “10/100” and UTP “FDX/HDX”
DIP-switches. Refer to the table below for a detailed explanation.
Switch
SW3 Switch
SW4 Switch
SW5 Function
AN 100 FDX The UTP port is set to auto-negotiation
with the following modes advertised:
100F, 100H, 10F, 10H
AN 100 HDX The UTP port is set to auto-negotiation
with the following modes advertised:
100H, 10F, 10H
AN 10 FDX The UTP port is set to auto-negotiation
with the following modes advertised:
10F, 10H
AN 10 HDX The UTP port is set to auto-negotiation
with the following modes advertised:
10H
MAN 100 FDX The UTP port is set to manual
negotiation and is forced to:
100F
MAN 100 HDX The UTP port is set to manual
negotiation and is forced to:
100H
MAN 10 FDX The UTP port is set to manual
negotiation and is forced to:
10F
MAN 10 HDX The UTP port is set to manual
negotiation and is forced to:
10H
3.2.1.4 SW4 - UTP 10/100Mbps “10/100”
When the UTP “AN/Man” DIP-switch (described above) is in the manual “Man” position, the “10/100"
DIP-switch determines the speed of operation for the UTP port. Setting the “10/100” DIP-switch to UTP
Page 7