Omnitron Systems Technology iConverter 10/100M - Manual (Page 6)

3.2 CONFIGURING DIP-SWITCHES
The 10/100M plug-in module has two board-mounted DIP-switches. The standalone unit has one bank of
DIP-switches. The locations of the DIP-switches are illustrated below.
DIP-switch Locations
3.2.1 Board-Mounted Bank 1 Settings
DIP-switch Bank 1 is available on both the plug-in and standalone modules. The table indicates the position
of the switch; Left/Down or Right/Up. As indicated in the DIP-switch location diagram, Left and Right
refers to the plug-in module and Down and Up refers to the standalone module.
(Left/Right) (Up/Down)
Switch
Left/Down
(Factory Default)
Right/Up
SW1
Off:
Pause Disable On:
Pause Enable
SW2
FDX:
Fiber Full-Duplex HDX:
Fiber Half-Duplex
SW3
AN:
UTP Auto-Negotiate Man:
UTP Manual
SW4
100:
UTP 100Mbps 10:
UTP 10Mbps
SW5
FDX:
UTP Full-Duplex HDX:
UTP Half-Duplex
SW6 - SW8 See Link Mode DIP-Switch Table in Section 3.2.1.6
3.2.1.1 SW1 - Pause Disable/Enable “Off/On”
When a port is operating in auto-negotiation, its Pause operation mode is determined by the Pause capability
advertised during auto-negotiation between itself and the link partner. The port advertises its Pause capability
during auto-negotiation based on the Pause Disable/Enable DIP-switch setting. Setting the Pause DIP-switch to
Page 6