Omnitron Systems Technology iConverter 10/100M - Manual (Page 33)

• Multiplexer State - Indicates the Multiplexer state (“Discard”, “Forward” or “Unknown”) of the remote
ports. If “Forward” is displayed, the remote partner is forwarding non-OAMPDUs to the lower sublayer.
If “Discard”, the remote partner is discarding non-OAMPDUs network frames. If “Unknown”, the
Multiplexer state of the remote partner is indeterminate.
• Parser Action - Indicates the Parser Action state (“Discard”, “Forward” or “Loopback”) of the remote
ports. If “Forward” is displayed, the remote partner is forwarding non-OAMPDUs network frames to
the higher sublayer. If “Loopback” is displayed, the remote partner is looping back non-OAMPDUs
network frames. If “Discard” is displayed, the remote partner is discarding non-OAMPDUs network
frames.
• Critical Event - Indicates the Critical Event state (“Yes” or “No”) of the remote partner. If “Yes” is
displayed, the local device has detected a Critical Event. If “No”, the local device has not detected a
critical event.
• Link Fault - Indicates the remote partner has detected a fault in the receive direction (“Yes” or “No”). If
“Yes” is displayed, the receive link is down. If “No”, the receive link is up.
• OAM Mode - Indicates the OAM mode (“Active” or “Passive”) of the remote partner.
• Supports - Indicates the supported options (Variable Access “Var”, Link Event Notification “Event”,
Loopback “LB” or blank if no options are supported) of the remote partner.
• OUI - Indicates the three hex byte IEEE organizational specific identifier (or blank if unknown) of the
remote partner.
802.3ah parameters can be accessed by selecting options 7 from the Port configuration screen. The fiber
configuration screen is displayed.
802.3ah Control - iConverter 10/100M iConverter, Serial Agent
Identifier -
Chassis Number = 1 Slot Number = 1 Model Number = 8919-0 Port # = 1
1: 802.3ah OAM State Enabled Local Status
2: OAM Mode Active Discovery State Incomplete
3: Loopback Mode Disabled Multiplexer State Forward
4: Loopback Timeout 30 sec Parser Action Forward
5: Unidirectional Mode Not Available
Remote Status
Discovery State Incomplete
Critical Event No
Link Fault No
Multiplexer State Unknown
Parser Action Unknown
Mode Unknown
Supports Unknown
OUI: Unknown
Enter, Previous Screen (0), (n)ext page, (H)elp, E(x)it >
To configure the 802.3ah parameters for the UTP port, type an n and press <ENTER>.
Page 33