Omni Group GREEN SMART 864 - Manual (Page 66)

66 Optional Equipment
(for qualified installers only)
© Travis Industries 4090507 100-01217_000
10 The stepper motor (adjustable regulator) has an installation sheet included with it – make sure to
follow all of the directions. Place the stepper motor on the gas control valve (see Figure 14) –
MAKE SURE IT IS CORRECTLY ORIENTED
. Secure using the screws included with the motor
(see Figure 15) – tighten to 25 Lb-inches. Leak test this area after installation to verify proper
installation.
Figure 14
Figure 15
11 Place the GreenSmart wiring harness in front of the fireplace, noting the position of each
connector (see .Figure 16).
Figure 16
12 Attach the wiring harness to the burner control (see Figure 17). Attach the gas control valve
molex connector (see Figure 18).
Figure 17
Figure 18