Quadra-Fire QFP38-NG - Manual (Page 20)

Quadra-Fire • QFP38 Series • 4061-300 Rev i • 9/09 20
Q. Lighting Instructions (IPI)
• For normal use, activate/deactivate your fi replace with the remote control.
• The IPI system may be operated with four AA batteries.
• If
your fi replace must be deactivated for serviced or an extended period of time, follow the instructions below.
A.
This appliance is equipped with an ignition device which automatically lights the pilot. DO NO
T
try to light the pilot by
hand.
B.
BEFORE LIGHTING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floo
r.
W
HA
T
T
O
DO IF Y
O
U SMELL
GAS
•
D
o not try to light any appliance.
•
D
o not touch any electric switch; do not use any phone in
your building.
•
Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's instructions
.
•
If you cannot reach your gas supplie
r, call the fire
department.
LIGHTING INSTRUCTIONS
T
O
TURN OFF GAS T
O
APPLIANCE
1.
Press “ON/OFF” key on the transmitte
r.
2.
Turn OFF all electric power to the appliance if service is to be performed.
3.
Turn gas supply OF
F.
Due to high surface temperatures, keep children, clothing and furniture aw
a
y.
Keep burner and control compartment clean. See installation and operating instructions accompanying the appliance.
W
ARNING:
If you do not follow these instructions exact
ly
, a
fire or explosion may result causing property damage, personal injury or loss of life
.
FOR YOUR
SAFETY
READ BEFORE LIGHTING
4061-309a
C.
Use only your hand to turn the gas control knob. Never use tools. If the lever or knob will not move by hand, don't try to repair it, call a qualified service technician. Force or attempted repair may result in a fire or explosion.
D.
D
o not use this appliance if any part has been under wat
e
r.
Immediately call a qualified service technician to inspect the appliance and to replace any part of the control system and any gas control which has been under wate
r.
This appliance needs fresh air for safe operation and must be installed so there are provisions for adequate combustion and ventilation ai
r.
This appliance must be installed in accordance with local codes, if any; if not, follo
w
ANSI Z223.1 or
, in
Canada, current CAN/CGA-B149.
W
ARNING:
Improper installation,
adjustment, alteration, service or maintenance can cause injury or property damage. Refer to the owner's information manual provided with the appliance. For assistance or additional information consult a qualified installe
r, service agency or the
gas supplie
r.
CAUTION:
Hot while in operation. Do not touch.
Keep children, clothing, furniture, gasoline and other liquids having flammable vapors aw
ay
.
WARNING RISK OF FIRE
This appliance is intended to burn a specified gas fuel onl
y. Do
not attempt to use with solid wood fuel or another type of fuel. Do not attempt to modify or use any other type of gas burner system.
*
Also certified for installation in a bedroom or a bed-sitting room
.
*
For U.S. only!
W
ARNING:
Disconnect the electric power before
servicing. If for any reason the original wire supplied with the appliance must be replaced, it must be replaced with 105° C or its equivalent
.
This appliance must be properly connected to a venting system in accordance with the manufacturer's installation instructions
.
NA
TURAL GA
S
1.
S
T
OP! Read the safety information above on this label
.
2.
Turn OFF the gas supply to the appliance.
3.
Turn OFF all electric power to the appliance.
4.
This appliance is equipped with an ignition device which automatically lights the pilot. DO NO
T
try to light the pilot
by hand.
5.
W
ait five minutes to clear out any gas. If you then smell gas,
ST
OP! Follow "B" in the safety information above on this label. If you
don't smell gas, go to the next step.
6.
To turn on the burner
, turn on all electric power to this appliance and
turn on the gas supply
.
7.
Press the “ON/OFF” key on the transmitter
.
8.
If the appliance will not operate, follow the instructions "T
O T
URN OFF
GAS T
O
APPLIANCE" and call your service technician or gas supplier
.
Gas Supply
Closed (OFF)
Gas Supply Open (ON)