Quadra-Fire QFP38-NG - Manual (Page 28)

Quadra-Fire • QFP38 Series • 4061-300 Rev i • 9/09 28
5 5
Framing and Clearances
A. Select Appliance Location
When selecting a location for the appliance it is important
to consider the required clearances to walls (see Figure
5.1).
WARNING! Risk of Fire or Burns! Provide adequate
clearance around air openings and for service access. Due
to high temperatures, the appliance should be located out
of traffi c and away from furniture and draperies.
NOTICE: Illustrations refl ect typical installations and are
FOR DESIGN PURPOSES ONLY. Illustrations/diagrams
are not drawn to scale. Actual installation may vary due to
individual design preference.
45 1/2in.
(1156 mm)
43 1/2 in. (1105 mm)
1 in.
(25 mm)
23 1/2 in.
(597 mm)
59 3/4 in.
(1517 mm)
59 3/4 in.
(1517 mm)
1 in.
(25 mm)
1 in.
(25 mm)
1 in.
(25 mm)
Top Vent
One 90° elbow
Horiz Term
45 1/2 in.
(1156 mm)
84 1/2 in.
(2146 mm)
6 in.
(152mm)
Figure 5.1 Appliance Locations
Note: Wiring for and the installation of the heat zone kit must
be done before framed enclosure is completed.