Quadra-Fire QFP38-NG - Manual (Page 60)

Quadra-Fire • QFP38 Series • 4061-300 Rev i • 9/09 60
F. Install Andirons, Lava Rock, Rockwool
• Remove four screws from the front of the hearth pan as
indicated in Figure 15.15.
Figure 15.16 Install Andirons
Figure 15.15 Remove Screws from Front of Hearth Pan
• Align the holes in the andirons with the holes in the
hearth pan and fasten, using the four screws removed
in the previous step. See Figure 15.16.
Lava Rock in this area
Figure 15.17 Install Lava Rock
• Place lava rock as shown in Figure 15.18 to cover the
front of the hearth pan and the front ridge of the burner
pan.
• Sprinkle vermiculite over lava rock.
Place Rockwool here
Rub Rockwool here
• Place pieces of rockwool on the front of the burner pan
in front of the logs. See Figure 15.18.
Figure 15.18 Place Rockwool
G. Complete Log Installation
• Place the last two logs in the lava rock and against the
andirons as shown in Figure 15.19.
Place last two logs as shown
Figure 15.19 Install Logs #4061-178 and #4061-179
WARNING! Risk of Explosion! Follow rockwool placement
instructions. DO NOT place rockwool directly over burner
ports. Replace rockwool material annually. Improperly placed
rockwool interferes with proper burner operation.
• Replace fi xed glass assembly.
• Rub rockwool over the burnt look on the two front logs
(as indicated in Figure 15.19). The particles left behind
will give the logs a glowing embers look.
Note: If sooting on logs occurs (LP units), readjust the
logs out of the fl ame.