Warning – Quadra-Fire Expression 36 QV36A-FB User Manual

Page 30

Advertising
background image

Quadra-Fire • Expression 36 (QV36A-FB) • 2062-900 Rev. S • 11/11

30

Fire hazard.

Do NOT change the valve settings.

• This valve has been preset at the factory.

• Changing valve settings may result in fi re

hazard or bodily injury.

HIGH ALTITUDE INSTALLATIONS

U.L. Listed gas appliances are tested and approved without
requiring changes for elevations from 0 to 2000 feet in the
U.S.A. and Canada.

When installing this appliance at an elevation above 2000 feet,
it may be necessary to decrease the input rating by changing
the existing burner orifi ce to a smaller size. Input rate should
be reduced by 4% for each 1000 feet above a 2000 foot
elevation in the U.S.A., or 10% for elevations between 2000
and 4500 feet in Canada. If the heating value of the gas has
been reduced, these rules do not apply. To identify the proper
orifi ce size, check with the local gas utility.

If installing this appliance at an elevation above 4500 feet (in
Canada), check with local authorities.

• Ensure that gas line does not come in contact with outer

wrap of appliance. Follow local codes.

• Incoming gas line should be piped into the valve

compartment and connected to the 1/2 inch connection
on the manual shutoff valve.

CHECK FOR GAS LEAKS

Explosion Risk

Fire Risk

Asphyxiation Risk

• Check all fi ttings and connections.

• Do not use open fl ame.

• After the gas line installation is complete, all

connections must be tightened and checked
for leaks with a commercially-available,
non-corrosive leak check solution. Be sure
to rinse off all leak check solution following
testing.

Fittings and connections may have loosened
during shipping and handling.

Fire or Explosion Hazard

• Gas buildup during line purge may ignite.

• Purge should be performed by qualifi ed technician.

• Ensure adequate ventilation.

• Ensure there are no ignition sources such as

sparks or open fl ames.

• A small amount of air will be in the gas supply lines.

When fi rst lighting appliance it will take a short time for
air to purge from lines. When purging is complete the
appliance will light and operate normally.

WARNING

WARNING

WARNING

Advertising