Texas Instruments TMS320C674X - Manual (Page 118)

EMAC Module Registers www.ti.com
5.39 Back Off Test Register (BOFFTEST)
The back off test register (BOFFTEST) is shown in Figure 77 and described in Table 76 .
Figure 77. Back Off Random Number Generator Test Register (BOFFTEST)
31 26 25 16
Reserved RNDNUM
R-0 R-0
15 12 11 10 9 0
COLLCOUNT Reserved TXBACKOFF
R-0 R-0 R-0
LEGEND: R = Read only; -n = value after reset
Table 76. Back Off Test Register (BOFFTEST) Field Descriptions
Bit Field Value Description
31-26 Reserved 0 Reserved
25-16 RNDNUM 0-3FFh Backoff random number generator. This field allows the Backoff Random Number Generator to be
read. Reading this field returns the generator's current value. The value is reset to 0 and begins
counting on the clock after the deassertion of reset.
15-12 COLLCOUNT 0-Fh Collision count. These bits indicate the number of collisions the current frame has experienced.
11-10 Reserved 0 Reserved
9-0 TXBACKOFF 0-3FFh Backoff count. This field allows the current value of the backoff counter to be observed for test
purposes. This field is loaded automatically according to the backoff algorithm, and is decremented
by one for each slot time after the collision.
5.40 Transmit Pacing Algorithm Test Register (TPACETEST)
The transmit pacing algorithm test register (TPACETEST) is shown in Figure 78 and described in
Table 77 .
Figure 78. Transmit Pacing Algorithm Test Register (TPACETEST)
31 16
Reserved
R-0
15 5 4 0
Reserved PACEVAL
R-0 R-0
LEGEND: R = Read only; -n = value after reset
Table 77. Transmit Pacing Algorithm Test Register (TPACETEST) Field Descriptions
Bit Field Value Description
31-5 Reserved 0 Reserved
4-0 PACEVAL 0-1Fh Pacing register current value. A nonzero value in this field indicates that transmit pacing is active. A
transmit frame collision or deferral causes PACEVAL to be loaded with 1Fh (31); good frame
transmissions (with no collisions or deferrals) cause PACEVAL to be decremented down to 0. When
PACEVAL is nonzero, the transmitter delays four Inter Packet Gaps between new frame transmissions
after each successfully transmitted frame that had no deferrals or collisions. If a transmit frame is
deferred or suffers a collision, the IPG time is not stretched to four times the normal value. Transmit
pacing helps reduce capture effects, which improves overall network bandwidth.
118 EMAC/MDIO Module SPRUFL5B – April 2011
Submit Documentation Feedback
© 2011, Texas Instruments Incorporated