Texas Instruments TMS320C674X - Manual (Page 74)

MDIO Registers www.ti.com
4.6 MDIO Link Status Change Interrupt (Masked) Register (LINKINTMASKED)
The MDIO link status change interrupt (masked) register (LINKINTMASKED) is shown in Figure 30 and
described in Table 28 .
Figure 30. MDIO Link Status Change Interrupt (Masked) Register (LINKINTMASKED)
31 16
Reserved
R-0
15 2 1 0
Reserved USERPHY1 USERPHY0
R-0 R/W1C-0 R/W1C-0
LEGEND: R/W = Read/Write; R = Read only; W1C = Write 1 to clear (writing a 0 has no effect); -n = value after reset
Table 28. MDIO Link Status Change Interrupt (Masked) Register (LINKINTMASKED)
Field Descriptions
Bit Field Value Description
31-2 Reserved 0 Reserved
1 USERPHY1 MDIO Link change interrupt, masked value. When asserted, the bit indicates that there was an
MDIO link change event (that is, change in the LINK register) corresponding to the PHY address in
USERPHYSEL1 and the corresponding LINKINTENB bit was set. Writing a 1 will clear the event,
writing a 0 has no effect.
0 No MDIO link change event.
1 An MDIO link change event (change in the LINK register) corresponding to the PHY address in
MDIO user PHY select register USERPHYSEL1 and the LINKINTENB bit in USERPHYSEL1 is set
to 1.
0 USERPHY0 MDIO Link change interrupt, masked value. When asserted, the bit indicates that there was an
MDIO link change event (that is, change in the LINK register) corresponding to the PHY address in
USERPHYSEL0 and the corresponding LINKINTENB bit was set. Writing a 1 will clear the event,
writing a 0 has no effect.
0 No MDIO link change event.
1 An MDIO link change event (change in the LINK register) corresponding to the PHY address in
MDIO user PHY select register USERPHYSEL0 and the LINKINTENB bit in USERPHYSEL0 is set
to 1.
74 EMAC/MDIO Module SPRUFL5B – April 2011
Submit Documentation Feedback
© 2011, Texas Instruments Incorporated