Toshiba Strata DK Backup - Manual (Page 74)

Flexible Button Programming Section –––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––
64 DKAdmin/DKBackup
➤
To copy the features from one port to another
1. Highlight the LED you wish to copy and press F4 . The Copy to Port dialog box displays.
2. Type the range of port numbers that you wish to copy TO.
3. Highlight the Button Assignment Column of Add-On Module 1 or 2 for the LED you wish
to change and press F3 . A message displays at the top of the screen:
Current template copied from port XXX.
Press Enter to display the Feature pop-up box.
4. Highlight the feature you want to assign to the button and press Enter . A value entry
pop-up box displays.
5. Enter the appropriate number or code for the selected feature. The feature is copied from
this port to the ports specified in Step 2 .
6. Repeat Steps 1 ~ 5 for each button you wish to copy.
7. Press F10 to save your changes and return to the Flexible Key Program Administration
screen.
➤
To clear the port
1. To clear the port and return to the default settings for all options, press F5 . A message
displays: Are you sure?
2. Press Enter to clear the port.
➤
To change an assigned feature
1. Highlight the Button
Assignment column
for either Add-On
Module 1 or 2 for the
LED you wish to
change and press
F6 .
A feature pop-up list
displays (shown right).
2. Highlight the feature
you want to assign to
the button and press
Enter . A value entry
pop-up displays.
3. Enter the appropriate
number or code for the selected feature.
Note You can only assign a feature to one button per port. If you attempt to assign a feature
already assigned, an error message displays.