Texas Instruments MSP430 User Manual
Page 132
Hardware Installation
www.ti.com
8. Note that Windows may show a warning that the driver is not certified by Microsoft. Ignore this warning
and click "Continue Anyway" (see
).
Figure C-4. Windows XP Driver Installation
9. The wizard installs the driver files.
10. The wizard shows a message that it has finished the installation of the software for "MSP-FET430UIF
(TI USB FET) Adapter" (or "MSP430 Application UART").
11. NOTE: This step is for MSP-FET430UIF and eZ430-F2013 only.
After closing the hardware wizard, Windows automatically recognizes another new hardware device
called "MSP-FET430UIF - Serial Port".
12. NOTE: This step is for MSP-FET430UIF and eZ430-F2013 only.
Depending on the current update version of the operating system, corresponding drivers are installed
automatically or the hardware wizard opens again. If the wizard starts again, repeat the previous
steps.
132
Hardware Installation Guide
SLAU278F – May 2009 – Revised December 2010
© 2009–2010, Texas Instruments Incorporated